DUMP TRAILER Energy UNIT- SINGLE ACTING
Common Description
This power unit features a energy up gravity down circuit. Begin the motor to extend the cylinder and activate the solenoid valve to retract the circuit. Guide override to solenoid valve could be supplied if required. Also a strain compen sated flow management can be added to your circuit to control the descent speed of the cylinder.
Remark: Please seek advice from our revenue engineer for your various pump displacement, motor energy or tank capacity.
Distinctive Notes
1. This electrical power unit is of S3 duty cycle, i.e., non-continuous operation, thirty seconds on and 270 seconds off.
two. Clean all the hydraulic components concerned just before set up of the electrical power unit.
3. Viscosity from the hydraulic oil shoud be 15~46 cst,which should also be clean and absolutely free of impurities.N46 hydraulic oil is recommended.
4. The electrical power unit should be mounted horizontally.
5. Check the oil degree inside the tank soon after the first operating with the energy unit.
6. Oil altering is needed following the initial one hundred operation hrs, afterwards after each and every 3000 hrs.
DUMP TRAILER Electrical power UNIT-DOUBLE ACTING
Standard Description
This electrical power unit has a electrical power up electrical power down circuit with load holding on both A & B ports. A stress compensatred movement 
management can be extra to circuit to control the decent velocity from the cylinder.
Distinctive Notes
1. This energy unit is of S3 duty cycle, i.e., non-continuous operation, 30 seconds on and 270 seconds off.
two. Clean all of the hydraulic components concerned in advance of installation of the energy unit.
3. Viscosity of the hydraulic oil shoud be 15~46 cst, which really should also be clean and absolutely free of impurities. N46 hydraulic oil is suggested.
4. The electrical power unit ought to be mounted horizontally.
five. Check the oil level from the tank after the preliminary running of your electrical power unit.
6. Oil changing is needed following the first one hundred operation hrs, afterwards after every 3000 hours.