Whenever a roller chain is used, shaft positions may be arbitrarily determined. On the other hand, in principle, follow the illustration shown under. That’s, if the chain is tensioned horizontally, continue to keep the best tensioned. Prevent vertical transmission each 
time attainable. In an inevitable situation, location the big sprocket in the bottom regardless from the path of rotation.
Once the chain layout is undesirable:
?Once the top rated is sagging along with the sprocket center distance is short:
As illustrated below, adjust the sprocket center distance shaft to reduce the sag.
?Once the prime is sagging as well as sprocket center distance is extended:
As illustrated beneath, set up an idler from inside to eradicate the sag.
?Once the chain is vertical or inclined:
Eradicate the extra sag by a tensioner. In this instance, a tensioner that automatically eliminates the sag gives superior final results.
Whenever a pulsating load acts in higher pace operation:
The chain’s vibration as well as load influence frequency or chordal action may well synchronize to amplify vibration about the chain. Considering the fact that vibration has an effect on the chain, take countermeasures to avoid vibration within the following measures:
?Change the chain velocity.
?Improve chain stress. On the other hand, note that over-
tensioning can shorten the life of your chain. ?Use an idler or tensioner to divide the span
?Install a manual stopper to stop vibration.
Note: Chordal action refers to the vertical motion of chain induced when it is engaged with sprockets.
Layout of chain place
Tags: