Power UNITS FOR LIFT TABLE

Power UNITS FOR LIFT TABLE 1
Common Description
This energy unit is made solely for your tiny lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This power unit is broadly utilized while in the sector of logistic gadgets which include minifork lift, scissors lift and ariel working platforms. The lower-ing movement is controlled by the solenoid valve together with the velocity managed from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE two
General Description
This power unit is designed solely for your medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve as well as pace managed by the adjustable needle valve. When the lift rises to a higher positoin, however the power provide is lower, the lowering motion is managed by the guide override function.
Electrical power UNITS FOR LIFT TABLE three
Common Description
This electrical power unit is designed exclusively for your big lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve as well as the pace managed by a pressure compensated movement manage valve.
Energy UNITS FOR LIFT TABLE 4
Standard Description
This energy unit is made exclusively to the substantial lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve as well as the pace controlled through the adjustable needle valve. When the lift rises to a high positoin, but the electrical power supply is cut, the lowering movement is controlled by the guide override function.
Distinctive Notes
one. This power unit is of S3 duty cycle, which may only get the job done intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean every one of the hydraulic elements concerned prior to installation of the electrical power unit.
three. Viscosity in the oil shoud be 15~46 cst,which need to also be clean and no cost of impurities.N46 hydraulic oil is advised.
four. Oil modifying is needed following the first 100 operation hours,afterwards as soon as every single 3000 hours.
five. The energy unit proven is intended to be mounted vertically.